- New Anti-Lift Design
- Assembly Contains All Necessary Hardware to Complete the Installation with 3/8" or 1/2" (10 or 12 mm) Tempered Glass
- Stainless Steel Construction
- Spanner Wrench for Installation Sold Separately
Le kit de fixation sur verre de portes coulissantes simples de la série Laguna de CRL contient tous les composants dont vous avez besoin (à l'exception du verre trempé) pour finaliser ce type d'installation. Ce modèle est utilisé pour des applications dont la porte coulissante simple est fixée sur une ouverture « tout en verre » dotée d'un mur sur un côté de la porte, d'une imposte en verre au-dessus de la porte et d'un panneau fixe en verre sur l'autre côté de la porte Les portes à deux vantaux ne sont pas adaptées à cette application. Les roulements supérieurs pour porte coulissante anti-effraction peuvent être fixés au verre soit en applique soit en affleurement (les deux types de fixations sont possibles). Les roulements sont dotés d'un dispositif d'ajustement vertical +/- 3,2 mm (1/8 po) pour faciliter l'alignement des portes. Ce système ne doit être utilisé qu'avec du verre trempé de 10 ou 12 mm (3/8 ou 1/2 po) uniquement. Le verre feuilleté n'est pas compatible. LIMITES DU SYSTÈME DE PORTE Poids de porte maximum : 100 kg (100 kg) Largeur de panneau maximum : 1,36 m (53-1/2 po) Hauteur de panneau maximum : 2,50 m (98-7/16 po) Longueur de rail maximum : 2,64 m (104 po)
NOTE: Bi-parting double doors are not possible for this application.
The Anti-Lift Sliding Door Top Rollers can be attached to the glass with either Surface Mount or Flush Mount Fittings (both are supplied). The Rollers have a 1/8" (3.2 mm) up or down vertical adjustment to aid in door alignment. This system should only be used with 3/8" or 1/2" (10 or 12 mm) tempered glass. Laminated glass cannot be used.
Complete glass fabrication details and drawings are available by contacting our Technical Sales Department.
DOOR SYSTEM LIMITATIONS: Maximum Door Weight: 220 Lbs. (100 kg)
Minimum Door Width: 37-13/16" (960 mm)
Maximum Door Width: 53-9/16" (1.36 m)
Maximum Door Height: 98-7/16" (2.50 m)
Maximum Track Length: 104" (2.64 m)
EACH KIT CONTAINS: Two CRL Laguna Series Anti-Lift Top Rollers with Glass Fittings
One CRL Laguna Series Top Sliding Tube with End Caps at 104" (2.64 m) in Length
One CRL Laguna Series Top Sliding Tube Wall Mount End Cap (Fastener to Wall is Not Included)
Six CRL Laguna Series Top Sliding Tube Glass Mount Clamps
Two CRL Laguna Series Door Stops (One Left Hand and One Right Hand)
One CRL Laguna Series Bottom Floor Guide
Product Warning:
STRUCTURAL DISCLAIMER - All customers who in any way utilize this product are solely responsible to consult a structural engineer to determine the suitability of the product for the intended use and site conditions. All installers must be qualified and have professional knowledge about compliance with local, state and federal regulations, safety factors, and the appropriate choice of fixing material and procedures.
NOTE: These fittings are not for use with laminated glass.
Most shipping weights are approximate and have not been verified. If the exact weight is needed in order to determine shipping costs, and shipping costs are required in order for you to complete your order, please request this prior to submitting your order by contacting CRL Customer Service. Product images shown are of the actual product or a close representation. Colors can vary depending on your computer's video card and on how your monitor's color is adjusted.